Turnigy 9x config for hexcopter

[Ibiza]

Hi there, I'm building a hexcopter and I use the pxfmini with Turnigy 9x transmitter and 8c with ppm encoder. I can't find anything about setting the tx up for a hexcopter. I have v2 Tx btw. So I decided to try my luck here, can someone please help me? I found lots of quadcopter tutorials but can I do the same for a hexcopter?

[imuguruza]

@Ibiza you don't need to do anything special. If your PPM Sum has the 8 channels connected from the RC receiver, is fine. Meaning this:

In the case of the hexa, the PXFmini will write its output in the first 6 channels of the servo rail:

You need to connect those first 6 channels to ESCs like this:

That's all!

Iñigo

[Ibiza]

Thanks for the info. But I mean what do I need to setup on my tx for settings? Because it has copter, plane, etc and lots of custom settings too

[imuguruza]

@Ibiza APM website has some guides about each RC.

Just put it into Mode 2 & configure a switch (in aux channels) if you want to use different flight modes.

Iñigo