Continuing the discussion from Question about simulation:
Hi @ahcorde,
When you give this suggestion, where exactly should we run this instruction?
I try to do so on the terminal I'm running the vehicle.sh but I get the following message
STABILIZE> Unable to find parameter 'ARMING_CHECK'
Also, nothing happens when I try to change modes say
STABILIZE> mode GUIDED
STABILIZE>
However from what I see everything is running normally
APM: Calibrating barometer
APM: Initialising APM...
APM: barometer calibration complete
Init Gyro**
Ready to FLY ublox
And I'm following the tutorials and documentation cited in the discussion. I'm able to bring up gazebo and the copter model and everything seems to be according to the tutorials. Am I missing something obvious?
Thanks a lot,
Hugo