Hello Erle Robotics Team,
I just started programming and experimenting with the software of the PXFMini, after that I got everything set up for the assembly as a quad.
Then the worst case scenario happened after i connected my 11.1V 3S LiPo Pack. I connected it the same way as in one of your Forum posts.
About 3 seconds after the connection, a little part on top of the PXFMini started smoking and I immediately cut off the LiPo Pack. But where the smoke came from is now a little hole. I tried to find out which part has been damaged, but couldn't find any about this one.
After the incident I tried connecting the PXFMini + Pi0 with the USB connector and everything is still working, also the LEDs on the PXFMini are still intact and reacting correctly.
I hope you can help me on this topic.