Good Morning @LanderU and the rest of the World
I spend some hours over this throughout the Weekend.
The Problem was on my side.... I was sure i use a RPi2 but i used a RPi1B+ .... so my bad.
Now i installed the PXFmini firmware via apt-get. and the Ardupilot seems to start (orange LED flashing)
But now i have another issue: as soon as i install the PXFmini firmware and the Ardupilot has loaded i cannot access the RPI anymore.
- via SSH it just doesnt let me connect...
- The erle WLAN is there but i cannot connect.
- Via the screen i get
Login timeout after 60 seconds and then it tries after 60 seconds again...
so what i did then was starting a gain with a fresh flashed sd-card and compiling the firmware manually
If i now try run the arducopter. the output is:
Raspberry Pi 1 with BCM2708!
Init APM:Copter V3.6-dev (401a6f53)
Free RAM: 262144
FW Ver: 120
MS5611 found on bus 0 address 0x00
DataFlash_File: buffer size=16384
▒ Q}▒▒ Q▒▒▒ Q▒ HMC5843: not a HMC device
**---- screen is clearing here so i did not get all of it maybe
it continues like this then:
rY▒▒$▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒d▒▒▒▒vx▒▒▒F▒ ▒▒"oW▒▒<V▒<▒#=▒▒PuTTYPuTTY▒3▒EKF2 IMU0 initial yaw alignment completew\▒3EKF2 IMU0 tilt alignment complete▒▒▒ Qu▒MPU: temp reset 2056 16
MPU: temp reset 2068 0
▒ Q▒▒▒▒754▒▒Q▒▒O?▒▒▒}$9▒j929▒2▒▒▒n▒▒▒ӻFX?1▒( ▒54▒▒Q▒▒O?▒▒!JLxN@.▒/MPU: temp reset 2092 11519
Interrupted: Segmentation fault