Hello, I have a problem with my drone, the drone does not respond perfectly to the orders. When I go down the throttles and he puts down time and the brain erle 3 flashes orange. is this normal? Thank you very much.Etienne.
It's a safety feature @etienne49, I guess you have armed the drone and not increase throttle.
Thank you to help me. Yes, made at the start, after the beep that's them blinking orange and impossible to arm the drone. Before that I did not turn off the drone and I shut it off manually. I have not touched to the sd card and it is from the second battery charge...
Please upload a video that shows the problem you're facing @etienne49
Here's the video https://www.youtube.com/watch?v=xS4r4sokxKk
It looks like you don't have connected right the RC receiver @etienne49 . At the Rc display there's no RX battery level.I can see it at this time of the video:
Yes, I think so too. In addition the receiver of the drone does not blink, is it normal?And how to connect it?
Show us how the RC receiver is connected to Erle-Brain 3. You need to connect it to the 14th pin of the servo rail.
You can see it on the video but it is plugged all the left when looking at the erle brain 3 from behind.
I think the RC receiver is plugged upside-down at the servo rail, the brown cable is at the top and I think is the - wire. So reverse it so you have the orange wire at the top @etienne49
I didn't have to think at all I was looking for a bigger problem...I have another problem with the battery charger, the led remains green all the time. the charger indicates three green led while the battery is discharged and it's been two hours since it loads.
@etienne49 could be that you have discharge it too much? They don't recover when they are below a voltage...
Ok. And I'm not a programmer, is it easy to connect the drone to mission planner?What are the characteristics of the drone because it asks me if it is a linux computer, If it is an APM, Bebbop 2 ...?
check this https://www.youtube.com/watch?v=M_CGk0z-A7o