i have assembled my erle-copter and followed all the instructions provided in assembly guide. but when i try to calibrate the ESC by following the given procedure it does not go in ESC calibration mode.
check this video:
i am using Turnigy TGY9x that came with my kit . and FrSky telemetry with D4R II receiver. do these components creating problem
the calibration way is the same.
Maybe, you need calibrate first the RC.
i am using Turnigy TGY9x that came with my kit . and FrSky telemetry with D4R II receiver. do these components creating problem?
Also you can check that the telemetry is connected correctly.http://docs.erlerobotics.com/brains/erle-brain-3/hardware/communications#rc-input
No, is not a problem.
i followed the instructions provided in the video but nothing is happening ..
could you please, record a video?
yes i am uploading it for you. Now the brain goes in ESC calibrating mode but no sounds when i re plug the power again. it does not recording the maximum throttle and not the minimum as well
Could you record a video an upload it please @Saqlain_Haider?
ESC calibration VIDEO here is the video of my erle copter. @imuguruza
My DIY kit came with " SimonK 30A 2-3S Brushless ESC With 5V 3A ESC For RC Model " ESCs. are these ESC compatible with erle brain ? because they have simonk firmware as mentioned here http://www.banggood.com/SimonK-30A-2-3S-Procedure-Brushless-ESC-For-RC-Model-p-919129.html
Yes, these ESC's are compatible with Erle-Brain. Please, record a full video with all steps.
@LanderU https://www.youtube.com/watch?v=sX5V2eC2Ts4 here the link of the video Regards@Saqlain_Haider
try the following:
@LanderU which channel rail i should connect my ESC to Erle brain to calibrate all ESCs one by one
check this page, (PWM section):
For example, ESC 1 to PWM channel 1.
@LanderU it means that i have to connect all the ESCs to their respective channel rails ?
For Example ESC 1 to channel 1 ESC 2 to channel 2 and so on ... ??
yes, try this way please.