So unfortunately, after many hours of trying to get this thing set up, I believe this will not work. I read here that it would work, but didnt have any jumpers around as you mentioned above to try it. Which pins have the jumper placed on them, and could you explain why this is required?
I have ordered an S.bus to CPPM encoder which should hopefully solve this issue, unless the jumper will do the trick. I was able to calibrate the controller in APM but was not able to arm the copter or get a gps lock. I see in your documents that you use the FySky D4R-ii receiver, if I were to just by this one would I be able to jump some pins and thats all?
Right now I have the servo wires hooked to the EB3 itself, correct me if im wrong, but the only wire that the receiver would have on it is going to the furthest left hand pins on the EB? Thanks in advance.