I notice that some of the components that I receive are different looking than what I see in the instruction manual on your site and the videos you have posted. That's o.k., but I am stuck on one thing the Receiver and the Telemetry.
Step #10 on instructions say to mount the RC receiver.
The only two components that even look like that I could find are the Turnigy 2.4 GHz component
and the D4R-II telemetry component. Since the Turnigy seems it belongs with the controller and doesn't have any pins to connect to Erle Brain III, I assume the D4R-II telemetry component is what step 10 is referring to since it had both antennae and cable and pins to connect to Erle Brain III, although it looks totally different from the picture and the youtube video.
But then I get to step 12 and it says to mount telemetry.
I have no component that looks like this in my kit.... So my question is, did I not order that component, did it not ship, or am I missing some step?
Also, I have another problem with GPS. The components I have in the kit are:
If I turn over the GPS/Compass component, I don't see anything that the cables would attach to... There is nothing to attach to:
As shown in Figure 13, the cables are attached to something under this "lid"
Finally, the connector component to the chassis in the instructions is quite different than the X connector I have and I cannot figure out how the X connector is suppose to fit on to the chassis so that the rod can be placed into it....
Thank you for your help.