Hey all, Im putting together my pi0drone and I want to double check the wiring setup before I fry anything. Here is a picture of me mocking up what I believe to be correct.
My first question is: does this look right(assuming the leads in the blue circle are connected)? The lead coming off the chassis is soldered on and powers all the ESCs through the body. Is the mini lead going to my pxfmini (circled in pink)correct? I don't have to do anything with the extra small lead off the battery (circled in green) do I?
Assuming everything is correct above, I want to know if I can remove the entire section (circled in red) where I soldered the lead onto the body and the yellow connectors (circled in yellow) and then just solder the output end of the power module directly to the body. I have found 2-3 posts already about this, but they weren't straight forward enough for me to feel comfortable cutting, soldering, and hooking everything up.
Third and final question, I hooked all of my motors wires up directly to the ESCs all in the same wiring order regardless of cw or ccw, is that ok? Im just talking about the wires from ESC to motor, I have the motor positions correct. From what I've read, since I have BLHeli ESCs, this should all be configurable on the software side.
Thanks for taking time out of your day to read my post, I really appreciate it!